Citrix NetScaler Under Attack: What Small Businesses Must Do
If your business lets anyone connect remotely through a VPN, firewall, or remote access appliance, the last ten days are worth your attention. Two critical flaws in a widely used piece of network hardware were being exploited by attackers before a fix even existed. That is the kind of event that should make any business owner stop and check what is sitting on the edge of their network.
What Happened
Over the weekend of September 27, CISA added two critical Citrix NetScaler vulnerabilities to its Known Exploited Vulnerabilities catalog, CVE-2026-88771 and CVE-2026-88772, and set a federal remediation deadline of September 30, 2026.
Citrix confirmed both were exploited as zero-days before patches shipped.
In plain terms: attackers were breaking into these devices before anyone had a way to close the hole.
Both vulnerabilities affect Citrix NetScaler ADC and NetScaler Gateway appliances and carry a CVSS severity score of 9.5, among the highest possible ratings.
Citrix has stated it observed exploitation on unmitigated deployments, and CISA reports threat actors are exploiting them globally.
Citrix released emergency patches covering eight vulnerabilities in total, and one of the flaws affects every deployment running an affected version, including those running default settings.
This is not an isolated incident. Earlier in September, CISA flagged a separate round of actively exploited flaws in the same category of equipment.
On September 9, the agency added four vulnerabilities to its Known Exploited Vulnerabilities catalog based on evidence of active exploitation, including flaws in Fortinet products, an earlier Citrix NetScaler authentication bypass, and a Cisco Firewall Management Center authentication bypass.
Three separate vendors, three separate incidents, one month. The pattern is the story.
What It Means for Your Business
NetScaler itself is more common in mid-size and enterprise environments, so you may not be running this exact product. But the lesson applies no matter what brand sits at your network edge. Firewalls, VPN gateways, and remote access appliances are the single most attractive target for attackers right now, because a successful break-in there gives them a foothold inside your entire network, not just one computer.
Small businesses are especially exposed for a simple reason: these devices often get set up once, during a move or a remote-work rollout, and then nobody touches them again. No one is watching for vendor security bulletins. No one is confirming the firmware got updated. The device quietly becomes the oldest, least-patched thing on the network, sitting with a direct connection to the internet.
The zero-day nature of this particular attack matters too. Patching after the fact does not undo a break-in that already happened. If a vulnerable device was exposed to the internet before the fix came out, the right move is not just to patch. It is to check whether anyone already got in.
What to Do This Week
- Ask your IT provider or internal IT person a direct question: do we run Citrix NetScaler, or any VPN/firewall appliance, and is it patched to the latest version?
Fixed builds exist for NetScaler ADC and Gateway 14.1 and 13.1, so if you run this product, confirm the version installed matches the current release. - If you don’t know what brand of firewall or VPN appliance your business uses, that is the first gap to close. Someone in your organization, even if it’s an outside vendor, should be able to answer that question in under five minutes.
- For any internet-facing device that was running a vulnerable version, ask for a log review, not just a patch confirmation. Exploitation before a fix existed means patching alone does not rule out prior compromise.
- Turn on multi-factor authentication for any remote access into your network, if it isn’t already required. It will not stop every attack of this type, but it closes off a large share of the easy ones.
- Set a standing reminder, monthly is reasonable, to check whether your network edge devices (firewall, VPN, remote access gateway) have pending security updates. This should not depend on someone remembering.
None of this requires a big budget or a new system. It requires knowing what you have and keeping it current, which is exactly the kind of thing that falls through the cracks in a business without dedicated IT staff. If you want a second set of eyes on what’s sitting at the edge of your network, Metamorphosis Consulting is happy to take a look and tell you plainly where you stand.